The used VECOPLAN VAZ 2500 single shaft waste shredder is in good condition and is available immediately ex site UK.
Delivered new in 2009, the VECOPLAN VAZ 2500 single shaft waste shredder
The unit is minus control panel.
Complete plastic washing recycling plant, trommel, float sink tank and plant available ex-worksViewings welcome £400,000
1,000 Litre Carbon tank for sale, now in stock.
2,000 Litre Carbon tank for sale, now in stock.
24,500 Litre Carbon tank for sale, now in stock.
3,000 Litre Carbon tank for sale, now in stock.
2 Available - £15,000.00 for 2- These were purchased new in 2013 and fitted in the container of a FG Wilson 1250kVA generator 3 of 11 supplied. These were never used - generator had 3 hours and air cooled via fans.
Buy more than 2 to receive a discount - 20ft HC acoustic containers CSC approved built 2015 Internal bulk head with engine room fan ducting Steel chequer plate bunded floor Internal fuel tank 1200 litre with twin fill Integral box silencer to suit 1000 kVa Cummins engine External pivot ladder with access to fuel coolers Chevron louvers front and rear with hinge side louver Roof fan frame from radiator cooling 4 door side access with stainless steel locking gear Colour Grey RAL7043 80% gloss 5 year warranty on paint
Schneider 2,000 Amp ACB 3 Pole fixed Manual Breaker.
This manual braker was previously installed but was never used.
500 kVA | 11,000 volt | 3 phase | 50Hz
Sold in good working order.
Full water treatment system available for sale with all associated pumps, starter panels, pipework and tanks included as a complete package.Tank sizes (approx only)
2 off cyclone towers including gearboxs
Pumps include 3 off submersibles, hard iron transfer pumps made by Linatex and dosing pumps.
Twin Blower system for aeration tank.
Any offers considered as space needed on site for further expansion.
Unit location: Near Attleborough, Norfolk
Should you require any additional pictures, information or would like to view the equipment please call or click the enquiry button.
Flanged (PN16) Stainless Steel Bellows for your generator from 100 - 250mm (ID).
This engine was purchased for a project, we did not go ahead with this particular project. The engine was not used. It is an air cooled version Hyd R+D test bed, it has only ever been used for approx 230 hours from new. The engine delivers 2200 RPM with a voltage of 218KW.
Complete with radiator, fly wheel, gas regulator and 12 volt electrics system.
Manufacturer advises that this engine was built to operate using most gases.
This engine is new and unused, surplus to requirements.
Used engine, this engine is a good runner bought for a project that we did not take forward. Although a great runner on testing it was noted that the engine is burning some oil hence priced to sell. Sold as seen with viewing recommended.
Used Gast 3040-V115A vacuum pump driven by a Honda petrol, recoil start engine 3.5hp mounted in a tubular steel protective frame.
Gast Rotary Vane air compressors and vacuum pumps are used in thousands of applications worldwide
Available in oilless, lubricated, motor-mounted, and separate drive styles, they offer a wide choice of capabilities.
Air flow from 24-32 cfm (41 to 55 m3/h), vacuum up to 20 in. Hg (400 mbar).
• Packaging • Graphic Arts • Pond Aeration • Vacuum Hold-Down • Air Sampling • Office/Business Machines • Food Processing Equipment • Laboratory Use • Soil Sparging • Vacuum Forming • Air Bearings
Brook Hansen CF280MN 185kW electric motor. Previously used to power a fire pump but removed as buyer requested the pump without motor.
Can be used to power a variety of other machinery.
Power: 185kW - Speed: 2950 rpm
Voltage: 415 - Current: 307 amps - Frequency: 50Hz
Brook Hansen 250kW electric motor. Can be used to power a variety of machinery including pumps, construction equipment,
industrial machines and chemical production equipment.
This unit has only been used for test hours which is believed to be about 40.
Power: 250kW - Speed: 1485 rpm Voltage: 415 - Current: 409 amps - Frequency: 50Hz
Weg 160kW electric motor. Can be used to power a variety of machinery including pumps, construction equipment,
industrial machines and chemical production equipment.
This unit has been used for test hours which are less than 60.
Power: 160kW - Speed: 1485 rpm
Voltage: 415 - Current: Upto 290 amps - Frequency: 50Hz
2 x Detroit Engines
Roots type blower / vacuum units. 2" pipework powered by a 7.5kW / 415V motor. Belt driven. Mounted in a sound reduction canopy (one of which has the doors missing).
Marine Weights. Weight of 15KG
Cast Iron, 100x500mm with 2x 16mm rope holes
We have a high volume in stock
UK business postage £8.00
UK residential postage £15.00
Suitable for Generator / Pump / Compressor. Previously used to house a 500kVA Volvo genset. In good condition. AC + DC Lighting by request. Can also be re-sprayed at extra cost.
Acoustic enclosure from former 630kVA generator set which was installed with a noise level of 75dBA @ 1 meter. This enclosure has the dimensions of 7 x 2.2 x 2.8 meters. This enclosure has 2 parallel doors, Due to storage we can not confirm the unit is fitted with a working exhaust however should one be required we can provide as an added extra with many in stock to suite.
This is a Rockwool-Zintec wall constructor and is suitable for generator - compressor or power packs, blowers etc.
Acoustic generator canopy which is surplus to requirements previously housed an FG Wilson P88E1. Generator was used as open sets for rental application. The silencer is included. Will be cleaned prior to sale as been in storage. We can offer this primed and repainted in a standard RAL colour if required (additional cost)
Acoustic generator enclosures which were surplus to requirements previously housed Cummins C45 to C110 range. Generators were used as open sets for projects. The silencer and integral fuel tanks are included. Will be cleaned prior to sale as they have been in storage. We can offer these primed and repainted in a standard RAL colour if required (additional cost) Choice available.
Once used to enclose a Cummins KTA38G3. Green with a red band this unit is sound attenuated to 85dba @ 1 metre, the unit has 4 access points and a floor it is not a drop over container. Finished and re-painted 2 years ago the enclosed generator was sold as an export separately.
Suitable for Generator / Pump / Compressor. 5m x 1.9m + end attenuator 1m x 7m. Height 2.44 metres fitted with 3 personnel doors. Had been used to house a 450 kVA Cummins generator achieving 75dBA at 1 metre we were advised. This is fully lined with 60KGm² Rock Wool. Exhaust Silencers new or used available. AC + DC Lighting by request.
Ex Ministry of Defence Cabin for sale.
Temporary or permanent liquid storage tanks with PVC or butyl liner, steel or permeable covers. Ideal for:
Tank capacity from 9m³ to 208m³ (1,990 to 45,750 gallons). Tank sizes from 3mtr to 12mtr in diameter. Link pipes for larger volumes or smaller foot print can be manually erected on a concrete or sand base. Supply only with instructions or installation service available at extra cost. Approved for the storage of water by the Ministry of Agriculture and the National Water Council.
Used generator fuel tank. This is an old fuel tank which is now surplus to requirements.
Sold as seen.
Tank Capacity: 1500 litres
W - 2010mm x H - 1530mm x D - 510mm
Used generator fuel tank with built in dual fuel transfer system. This is an old fuel tank which is now surplus to requirements.
Sold as seen.
Tank Capacity: 500 litres
W - 1155mm x H - 905mm x D - (560mm Centre) (460mm Top + Bottom)
W - 1500mm x H - 2060mm x D - 600mm
Reiss Wey 200 (6") knife valves - approx. 10 in stock
4" = £40.00
6" = £70.00
8" = £160.00
Sapag 6" Gear Box Butterfly Valve - ex fire-pump
PN16 10"/250mm Gate Valves which were removed from
an ex fire pump installation.
4" £5 each
6" £11 each
8" £16 each
Fire pump ring main pipe clamps.
Available in 4", 6" and 8".
Fire main orifice plate flow meter for fire pump installations. 200mm diameter.
8" non return valve for preventing flow returning when pumping. Saving the need to repump any fluids.
Pressure reduction valves for controlling the pressure
within pumping systems.
Two 6" available and one 4".
Air Stripping Tower for removal of dissolved phase volatile organic compounds. Also Smaller sizes are in stock, singles, triples and large 9 x 1.2 mts models all serviced, clean full of pall rings and ready to use.
Floating oil recovery unit by RoClean powered by Yanmar L40AE-D 3.1kW diesel engine with spark arrestor. Complete with oil holding tank, map and reel.
V Notch Stilling Tank for sale. Shown is small at 850 to rectangular weir plate tanks at 3750 big range in stock at selling prices Also oil free product recovery tanks at £1850 each
Automotive Product. Model 11.5 RHD 2. ASS No. 62077. S/No 84457. Output Shaft 65mm. Engine PCD 465-470mm.
Large silencer for high power FG Wilson generators.
Part No. 130-509
Will fit FG Wilson Generator sizes P27 to P110.
Inside Length: 1190mm
Overall Length: 1370mm
Spigot Diameter: 75mm / 3 inches
Large SD250 industrial silencer for high power generators.
Inside Length: 1830mm - Overall Length: 1980mm
Flange Diameter: Inside: 260mm - Fixings: 360mm - Outside: 406mm
Large silencer for
high power generators.
Inside Length: 1510mm - Overall Length: 1660mm
Flange Diameter: Inside: 200mm - Fixings: 300mm - Outside: 340mm
Large anti vibration mounts for high power generators and other stationary vibrating plant machinery.
One example of use is for generators stationed on building sites in residential areas, reducing vibration noise.
Height: 75mm (excluding base plate)
Bolt Size: 20mm
Fixing Hole Width: 19mm
Used tilt bucket.
Comes from an old Kubota mini digger.
Used digger bucket.
Comes from an old Kubota mini digger.
The middle tooth has broken off of this bucket.
Can be fitted to tractors or other similar plant machinery.
This engine is new unused stock which is surplus to requirements.
This engine was removed and kept from a worn out pump, Not warranted as although stored it has been out of use for approx 3 years.
Flygt Mixers 4650.410 5 KW x 415 volt on Guide Rails. In good working order.
GEC Alsthom 2,000 kVA transformer.
2,000 kVA | 415 volt | 3 phase | 50Hz.
Atlas Copco GA 132W (version 100 - 60 Hz / 440V) Marine Compressor, removed from standby vessel (FAR SCOTIA). Engine room use, in excellent condition.
Will run at 50Hz.
Approx 250 hours run
Teagle Topper 8, Offset Topper grass cutter.
Teagle Toppers are suitable for:
Agricultural pasture, Playing Fields, Leisure areas and Amenity applications.
Hatz Supra 81 air-cooled, diesel engines. Were previously coupled to water pumps and replaced by electric motors. Were in good working order when removed, we should have all panels.
Hydrovane HV02 air compressor with a WEG 2.2kW, 415V, 2850 rpm electric motor.
Used for electronics, laboratories, dentistry, laser cutting, packaging, spraying, robotics and a multitude of OEM applications.
Clarke TK6HUF60 fire pump 6 cylinder engine. This engine is rated from 170 - 175 BHP and 2600 - 2800 RPM.
This engine can be coupled with many fire pumps including SPP and Armstrong.
Manufactured 11/2002, running hours are 64.
Surface water carbon adsorber. If you know what a carbon tank is then you'll know that these are the best. These units were last used 18 months ago as final water polishing at a chemical works We have owned them for 6 years and used them with great success. We have 3 of these tanks and a selection of small units.
Electric driven Mega van for sale (12 battery model). The van has MOT and is Taxed until 31 Oct (Tax is free of course). It also has brand new batteries and battery charger. It is very clean inside and out - only 5955 miles on the clock.
ADE manufactured brown fuel tank. Being sold in a new condition and manufactured in 2013.
New and unused Grundfos pressure vessel. Excellent condition. Dirt in images due to being moved around site.
This engine was replaced as the head failed.The Block and Crank are good. This item is sold as spares.
Used cement mixer. Has been sitting around site for several years. Surplus to requirements.
360° Clamshell bucket for excavating and trenching. Can also be used for moving goods or materials around hard to access sites.
Mori Raddrizzatori Micro-Tech-A automatic 240V, 3.2kW, 15.8A battery charger. Suits 260ah - 396ah battery capacity. Includes DC plug/socket
Thwaits dumper, used as a yard tug all good working order but warn. The engine is a perkins and this engine starts and runs well.
Used generator fuel tank fitted to an elevated 4 legged frame. This is an old fuel tank which is now surplus to requirements.